How to easily and quickly program the ESP8266 module via an arduino using the arduino IDE with example.

Link to paste :
Download The Arduino IDE :
ESP Pin Diagram :

Q. Getting Error : espcomm_upload_mem failed
A. Make sure that the GPIO 0 pin is connected to ground(GND) and the esp module is getting power.

Q. Can’t Install the ESP board?
A. Make sure that you have a reliable connection to the internet.

Q. My sketch doesn’t run after I power the the ESP again?
A. Make sure that the GPIO 0 pin is disconnected if you want to run a sketch. Reconnect it if you want to program the board.

Q. I did everything right but I still get error during upload?
A. Go to tools, upload speed and try uploading with different speeds either ‘115200’ or ‘9600’ should work but if they don’t try the other ones.

Q.How do I power the ESP without a arduino?
A. You can use a 3.5v LiPo battery or a breadboard power supply like the one I showed at the end(link below) or use 3 AA cells in series.

******PURCHACE LINKS******
Buy ESP8266-01 Module :
Buy Arduino Nano :
Buy USB to TTL Adapter :

Make The Breadboard Adapter :
Buy The Breadboard Adapter :
Buy Jumper (Dupont) Cables :
Buy Breadboard Power Supply :

Music : Invisible by Vibe Tracks

Tags: esp8266 beginners guide
how to use the esp8266
how to program the esp8266 using arduino


Leave a Reply